Scooter-Area

Scooter Tuning
 
HomePortalFAQSearchRegisterMemberlistUsergroupsLog in

Share | 
 

 Ditech popis gresaka

Go down 
AuthorMessage
P.A.L.A.C
Admin
avatar

Male Number of posts : 86
Age : 30
Lokacija : Vukovar
Vozi : NRG Power
Registration date : 2007-10-26

PostSubject: Ditech popis gresaka   Sat Oct 27, 2007 10:39 am

1 Engine overheated - cooler (radiator) damaged
- housing damaged
- not enough water in
radiator (cooler)
- check thermostat and cooler
- check damage on housing
- add some more cooling liquid

2 No signal from electronic
(CDI) for ignition
- Pick-Up cable connected
wrong
- Pick-UP cable damaged
- Check, and replace if needed
- Check, and replace if needed

3, 4, 5 Nothing to do with engine
errors, etc.. - water on junctions
- check that cables are
connected or damaged
- wait till it drys
- check, check and recheck

6, 7 Error on electronics - water in electronics
- sensor used up
- cdi died
- dry and isolate
- replace
- replace

8 General error in
electronics
- idle throttle higher then it
should be
- cdi died
- reprogram
- replace

9 Error in alternator or in
sensor for current
- empty battery
- contacts on battery loosen
- injectors relays died
- generator died
- recharge or replace
- clean contacts
- check and replace if needed
- check and replace if needed

10 Error in oil pump - pump died
- error in electronic - check
- if so, after reset, the injectio
check should also blink 16x

11 Error in air injector - relays of injector used up - replace
- air injector died
- electronic damaged
- fuses died
- clean or even replace
- reprogram or replace if needed
- replace

12 Error in fuel injector - same as above - same as abve

13 Error on ignition
- cable for sparkplug
damaged
- relays in injector damaged
- cdi died
- electronic damaged
- check or replace
- go to official servise or replace
- replace
- check fuses or even replace

14 Error in fuel pump - weak battery
- electronic died
- pump died
- replace or recharge
- replace
- check and replace if needed

15 Engine done too much
RPM's (usually after
downhill)
- it means that rpm limitar
worked, that it has been
turned on
- noting wrong, just restart system
4 times to reset that

16 Error on ECU
- error in program - reprogram

18,19 Error in temp sensor
-cable damaged
- sensor died
- ECU died
- check or replace
- replace
- reprogram or replace

20 Error in heat indicator
- cable that is connected to
instrument is damaged
- ECZ died
- check or replace
- replace or reprogram
Back to top Go down
View user profile http://scooter-world.forumotion.com
 
Ditech popis gresaka
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Scooter-Area :: Skuteri / Tehnika :: FAQ (tuning i tehnika)-
Jump to: